Nortel Networks 24T Uživatelský manuál stáhnout pdf (Strana 131)

Installing the BayStack 410-24T Switch

309985-B Rev 00

2-17

Initial Setup

The BayStack 410-24T switch is designed for “plug-and-play” operation; in most

cases the switch can be installed and made operational using the system default

settings (see Appendix E, “Default Settings,” for a list of default settings for the

BayStack 410-24T switch).

However, for the switch management function to become fully operational, certain

parameters must be configured. A minimal configuration is required when you

plan on remote management or TFTP operations.

If you are configuring your BayStack 410-24T switches into a stack configuration,

you will need to supply additional parameters to properly setup the stack.

This section includes the following information:

• Instructions for the initial (standalone) switch setup

• Instructions for the initial stack setup

After setting up your switch or stack configuration as described in the following

sections, proceed to Chapter 3, “Using the Console Interface,” for detailed

descriptions of the menus and screens you can use to customize your

configuration.

Standalone Switch Setup

For the initial setup of a standalone switch, you need to enter the IP address of the

switch, the subnet mask, and the gateway address (refer to Chapter 3, “Using the

Console Interface,” for more information about configuring your BayStack

410-24T switch).

To set the IP address, subnet mask, and gateway address for the switch:

Apply power to the switch.

After the Nortel Networks logo screen appears, press [Ctrl]-Y.

The Main Menu is displayed (Figure 2-13

). The Main Menu hierarchy is

described in Chapter 3, “Using the Console Interface.”

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 309 310

Žádné komentáře

Nortel Networks 24T Uživatelský manuál Strana 131