Nortel-networks Server 1005r Uživatelský manuál stáhnout pdf (Strana 35)

Connecting the server to the ELAN subnet 35

Connecting the server to the ELAN subnet

Introduction

Connect the CallPilot server to the Meridian 1 switch or CS 1000 system

using the ELAN subnet.

Note: If you are installing a High Availability system, do not connect

either sever to the ELAN subnet. The connection to the ELAN subnet is

made when you conﬁgure the system.

ATTENTION

For important considerations about using the ELAN subnet in your network, see

the Planning and Engineering Guide (NN44200-200).

ATTENTION

To comply with EMC radiation requirements, a Class A Ethernet switch or hub

must be located 10 m (33 ft.) away from the 1005r server. You must use shielded

Ethernet cables.

To connect the server to the ELAN subnet

Step Action

See the diagram on page "Rear panel connectors" (page 31) to

locate the ELAN Ethernet connector.

Connect an RJ-45 network cable from the ELAN Ethernet switch or

hub to the ELAN connector on the server.

Note: The ELAN Ethernet switch or hub is optional if you use

a cross-over network cable to make a direct point-to-point

connection from the server to the switch. However, if you choose

to establish a direct point-to-point ELAN connection, no other

device can connect to the ELAN subnet.

At the switch, connect the ELAN network cable to the ELAN Ethernet

interface. Complete the connection from the transceiver to the

switch.

DANGER

Risk of ﬁre hazard

Do not install a Media Access Unit (MAU) in ducts,

plenums, or other spaces used for environmental air. Do

not install a MAU above a false ceiling or below a raised

ﬂoor, unless you can conﬁrm that these spaces are not

used to convey environmental air.

Nortel CallPilot

1005r Server Hardware Installation

NN44200-308 01.06 Standard

5.0 15 May 2008

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 53 54

Žádné komentáře

Nortel-networks Server 1005r Uživatelský manuál Strana 35