Nortel-networks Passport 8002PS Uživatelský manuál stáhnout pdf (Strana 8)

3. Push the power supply partway into the bay.

Leave the terminal block at the side of the

power supply exposed.

9412FA

Note: If you are installing a power supply in a new chassis, be sure to remove the bag of

moisture-absorbing material from the middle power supply bay.

Warning: Make sure the DC power source is off or disconnected on the remote end before

you connect the terminal leads to the power supply. You may need to switch a circuit breaker

or turn off the DC input power source.

4. Attach the grounding cable to the ground lug

on the power supply.

Use the washers in this order:

• Flat washer

• Crimp lug

• Lock washer

• Hex nut

5. Attach the positive and negative voltage

leads to the positive and negative terminals

on the power supply.

Use a lock washer between the crimp lug and

each hex nut.

Use a 7/16-inch wrench to tighten the hex

nut on each terminal.

+DC

-DC

9415FB

+DC

-DC

9427EB

-DC

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Nortel-networks Passport 8002PS Uživatelský manuál Strana 8