Nortel-networks Circuit Card 311 Uživatelský manuál Strana 77

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 113
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 76
Trunk cards 77
LD 54
ATST l s c u loop, shelf, card, and unit numbers
If the system response is other than OK, see Software Input/Output
Reference Administration (NN43001-611) to analyze the
messages.
3 End the session in LD 54:
****
—End—
Network cards
Procedure 8
Testing network cards
Step Action
Use this procedure to test a network card.
1
Log into the system:
LOGI (password)
2
Perform a network memory test, continuity test, and signaling test:
LD 30
LOOP loop can be a specific loop number or ALL
If ALL is specified, all enabled loops (except attendant console
loops) and all shelves on each loop are tested.
If only one loop is being tested and it is disabled, enter ENLL loop
to enable and test a network card associated with the specified loop.
(This command cannot enable network cards disabled by LD 32.)
If the system response is other than OK, see Software Input/Output
Reference Administration (NN43001-611) to analyze the
messages.
3
End the session in LD 30:
****
—End—
Trunk cards
Use the following procedures to test a trunk card.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.
Zobrazit stránku 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 112 113

Komentáře k této Příručce

Žádné komentáře