Nortel-networks Server 600r Uživatelský manuál stáhnout pdf (Strana 31)

Connecting peripherals to the server 31

WARNING

The terminator is not a hot-plug device. If you replace the

terminator, or if you add an external SCSI peripheral, the server

must be powered off. If you replace the terminator or add a SCSI

peripheral when the system is on, the system can crash.

Step Action

Power off the server and the tape drive.

Note: For the proper shutdown procedure, see the chapter,

"Starting up and shutting down the CallPilot server" in Installation

and Conﬁguration Task List (NN44200-306).

Set the SCSI ID push button switch, located on the back of the tape

drive, to 6.

Connect the external SCSI tape drive to the SCSI port in the rear

panel, Label C on the rear panel diagram, as shown in Figure 7

"Rear panel" (page 29).

Note: You must remove the server terminator before you

connect the tape drive to the server. Keep the server terminator

in a safe place, as you may need the server terminator when

you want to use the server, and the tape drive is not available to

terminate the SCSI bus.

Figure 8

SCSI tape drive with terminator

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.0 14 May 2008

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Žádné komentáře

Nortel-networks Server 600r Uživatelský manuál Strana 31