Nortel Networks Nortel Secure Network Access Switch 4050 Uživatelský manuál stáhnout pdf (Strana 277)

100

101

Chapter 6 Configuring authentication 277

Nortel Secure Network Access Switch 4050 User Guide

2 Modify settings for the RADIUS configuration as necessary.

Table 42 describes the Radius Configuration fields.

Table 42

Radius Configuration fields

Field Description

Vendor Id for Group

Attributes

Specifies the vendor-specific attribute used by the RADIUS

server to send group names to the Nortel SNAS 4050. The

default Vendor-Id is 1872 (Alteon).

To use a standard RADIUS attribute rather than the

vendor-specific one, set the vendor ID to 0 (see also

vendor type).

Note: If the Authentication Protocol is CHAPv2, the

Vendor-Id must be set to 311 (Microsoft).

Vendor Type for Group

Attributes

Specifies the Vendor-Type value used in combination with

the Vendor-Id to identify the groups to which the user

belongs. The group names to which the vendor-specific

attribute points must match names you define on the Nortel

SNAS 4050. The default is 1.

If you set the vendor ID to 0 in order to use a standard

RADIUS attribute (see vendor ID), set the vendor type to a

standard attribute type as defined in RFC 2865. For

example, to use the standard attribute Class, set the

vendor ID to 0 and the vendor type to 25.

Vendor Id for Domain ID

Attributes

Specifies the vendor-specific attribute used by the RADIUS

server to send domain names to the Nortel SNAS 4050.

The default Vendor-Id is 1872 (Alteon).

Note: If the Authentication Protocol is CHAPv2, consider

setting the Vendor-Id for the domain to 10

(MS-CHAP-Domain).

Vendor Type for Domain ID

Attributes

Specifies the Vendor-Type value used in combination with

the Vendor-Id to identify the domain. The default is 2.

Radius Server Timeout Sets the timeout interval for a connection request to a

RADIUS server. At the end of the timeout period, if no

connection has been established, authentication will fail.

Acceptable values are an integer that indicates the time

interval followed by a letter to specify the measurement

unit. The options for measurement units are:

• s — seconds

• m — minutes

• h — hours

If you do not specify a measurement unit, seconds is

assumed. The range is 1–10000 seconds. The default is

10 seconds.

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 921 922

Komentáře k této Příručce

Žádné komentáře

Nortel Networks Nortel Secure Network Access Switch 4050 Uživatelský manuál Strana 277

Komentáře k této Příručce

Související produkty a manuály pro Software Nortel Networks Nortel Secure Network Access Switch 4050