Nortel Networks Nortel Secure Network Access Switch 4050 Uživatelský manuál stáhnout pdf (Strana 770)

100

101

770 Chapter 16 The Command Line Interface

320818-A

When using a Telnet or SSH client to connect to a cluster of Nortel SNAS 4050

devices, always connect to the Management IP address (MIP). Configuration

changes are automatically propagated to all members of the cluster. However, to

use the

/boot/halt, /boot/reboot, or /boot/delete commands, connect to

the Real IP address (RIP) of the particular Nortel SNAS 4050 device on which

you want to perform these commands, or connect to that Nortel SNAS 4050 with a

console connection.

Connecting to the Nortel SNAS 4050

You can access the CLI in two ways:

• using a console connection through the console port (see “Establishing a

console connection” on page 770)

• using a Telnet connection or SSH connection over the network (see

“Establishing a Telnet connection” on page 772 or “Establishing a connection

using SSH” on page 773)

Establishing a console connection

Use a console connection to perform the initial setup and when reinstalling the

Nortel SNAS 4050 software as the boot user. You must also use a console

connection when logging in as root user for advanced troubleshooting purposes.

1 2 ... 765 766 767 768 769 770 771 772 773 774 775 ... 921 922

Komentáře k této Příručce

Žádné komentáře

Nortel Networks Nortel Secure Network Access Switch 4050 Uživatelský manuál Strana 770

Komentáře k této Příručce

Související produkty a manuály pro Software Nortel Networks Nortel Secure Network Access Switch 4050